MTH0303PA VmaxMTH for coal-bed methane gas recovery
The VmaxMTH systems are air-cooled (no cooling water required) and are particularly suitable to operate as a vacuum compressor that will not overheat. Maximum differential pressure capability is 18-30 psi depending on system model. These systems have a proven track record in the coal-bed methane gas recovery industry.
Product Features
A true vacuum-compressor that will not overheat while pulling down to 18"Hg on suction and compressing on discharge
Easy flow control with customer's manual or automatic bypass valve
Heavy duty permanently sealed bearings eliminate periodic greasing
Direct drive, slow speed (1750 RPM) eliminates the use of V-belts
Features single face mechanical shaft seals as standard
No close internal tolerances. Eliminates lockup potential
Discharge temperature below 180F throughout the operating range
Extended-life seal-fluid is not used as a lubricant which provides long change interval
TEFC motor and NEMA 4 safety devices are standard. Optional explosion proof motor and NEMA 7 safety devices are available
Features Dekker's patented, high-efficiency DX-5 gas/oil separator which eliminates oil carry-over concerns
Ability to pass moisture without damage to the vacuum-compressor
Read More
